"Fell Asleep Here" Bookmark

I'm obsessed with the look of a catchy phrase or even a snarky saying showing not only where I left off in my book but also either what interrupted my reading (i.e. the kids started fighting) or my favorite book quote (i.e. I will not die today)! These bookmarks do just that!

 

IMPORTANT: Due to the size and height of these bookmarks, they can be finnicky, so please follow my settings and work with a clean build plate. I have tested these again and again and finally found settings that work without warping or misaligning. I work on a P2S, and it's the only printer I am truly familiar with. However, if you run into any issues, please message me, and I will do my best to help you troubleshoot! As a general rule of thumb for this design, I HIGHLY recommend a LARGE brim (mine is an outer only at 15mm), a slightly higher heat setting on your plate (mine is 60 on the textured plate), and a lower cooling setting (mine is 80%). Without these, the design can warp at stress points.

 

If you are interested in selling prints of this model, you can become a commercial member via my Patreon.

Boost MeA boost is GREATLY appreciated!!