Desiccant boxes for ams 2 pro

Desiccant boxes for the ams 2 pro to help with the moisture inside

You can print with the hygrometer or you can print it without, you can buy on bambu labs site

It print on one plate everything 

I will recommend to print it in abs so it has better heat resistance and you can dry pla and petg but petg is also fine if you only dry pla, you can also print it in pla but then you shouldn't use the dryer

Boost MeIf you like the model                                          
It means more than you think

When every box is filled to the max it uses about 350 grams of silica gel/desiccant

 

 

Assembly guide:

 

Slide the tunnel over the desiccant box and fill it with silica gel. Do it with all of the boxes.

Slide the lid over to close it. Do it with all of the boxes.

If you have the hygrometer press it in the middle box.

To insert the boxes you need to get the perfekt angle, it looks like this.

Do it with all of boxes in the front.

The rear box, you just have to press it down.

If you want to get it out again push in on the bottom of the rear box and you can tilt it out from the top.

 

Hope you like the model;)