Flik parts - Complete set for FlyingRC F405 wing

This is my setup for the Flik
https://epicfpv.ca/products/alight-wing-flik-mini-fpv-airframe-kit?srsltid=AfmBOooFEfAe4T4Ahh3AsRlroQLNPnttkeypu8WRXS6jdsYPmyow6wf0

Only the front camera mount is printed using TPU, otherwise all in PLA.

All parts are held in place using E6000 glue.

The flight controller is a FlyingRC F405 sold on Aliexpress for about $20 CAD.

GPS is a FlyWoo nano

A couple parts are remixed from nclncl
Check out his creations here: https://www.thingiverse.com/nclncl/designs

Description of the parts:
Battery tray: My setup is for a 6S 650mah but should work for many others
Canopy Latch: Printed this https://www.thingiverse.com/thing:7015056 but it ends up loose, so I added this part to the fuselage to make it tighter.
FC_bottom: It's a remix and added the original holder for the Flying RC FC
GPS: Again a remix and then modded to hold the FlyWoo GPS
O4 25x25 front support: This allows you to add the AirUnit in the front as far forward as possible. You can glue nylon M2 screws onto the stubs.
O4 lite support: It holds the camera perfectly in place in the front.
Wire_Management: Simple piece to manage the wires in the back.