Wicked Hueforge

Hueforge inspired by Wicked

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 160x240mm in size

You can change the X and Y axis, DO NOT CHANGE THE Z AXIS 

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.23997mm

    #080a0d PLA PolyLite Black  Transmission Distance: 0.3
    #3f8e43 PLA BambuLab Basic Mistletoe Green  Transmission Distance: 1
    #003b3b PLA BambuLab Basic Green  Transmission Distance: 2
    #fce300 PLA BambuLab Basic Yellow  Transmission Distance: 6
    #e2dedb PLA PolyLite White  Transmission Distance: 5
    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
This print uses 6 unique filaments

Swap Instructions:
    Start with Black
    At layer #10 (0.88mm) swap to Mistletoe Green
    At layer #13 (1.12mm) swap to Green
    At layer #17 (1.44mm) swap to Yellow
    At layer #23 (1.92mm) swap to White

This slider is set higher than the mesh depth.  It is not affecting your final mesh.  Consider removing it.

Border Only Colors from here until the end.
    At layer #28 (2.32mm) swap to Black for the rest.