A 20 slice, XL version is available too. It is currently in early access for my Patrons! 🖤🦊
Going back to my nerd roots, with this one. I've playing D&D for the last 8+ years & it's 1 of my favorite things to do.
I hope this brings some joy & laughs to your tabletop gaming. You're bound to be the favorite role player if gift these to the part!
Notes:
- Still uses a tiny, center supporter
- I 100% admit that this is sharper than most of my other twisty fidgets (please, be careful)
- I've done my best to loosen this one up a little bit
- I highly recommend Matte PLA, if you have issues with sliding/fusions
More Notes (Identical to some of my other models):
- Increasing Success (if you run into issues):
- Reduce print speed
- Adjust brim (increase size, reduce distance)
- Increase plate temperature 3-5°
- Use hairspray (Rave 4x Mega Hold) or plate glue
- Increase "CenterSupporter" (center supporting cylinder) infill to 3–5%
- Increase z-hop to 0.6-0.9mm
- Turn off “Reduce Infill Retraction”
- Profile Notes:
- I do not hesitate to report poor/unfair ratings due to issues with hardware, general bed adhesion, or attempting to print multiple on a single plate
- You are rating MY specific profile & my model, not the adherance of your plate or your ability to alter the profile to fit your needs
- I am approachable & genuinely looking to improve. Please, provide feedback/details/pictures
Toddy's Trinkets
