ACOG for MILITECH Rifles

ACOG TA31 for use on MILITECH AR15 Rifles. You will need his AR15 or other models. Not shown in picture, there is a piggy back red dot that fits on the back. The models are already oriented in the best strength vs quality position.

Print Settings:

ACOG Scope 60% infill, full supports

Turrets and red dot 100% infill, supports from build plate only

Assembly:

There is a small tab on the inside of the rail slot. This is intentional and you need to scrape, file, or sand it down until it is able to slide onto the top of the receiver snug but not loose. You will have to super glue on the turret knobs and red dot if you want them attached. I used a piece of red filament for the tritium tube on top. You can use a different color and paint it. Just snip it to size and glued it on just like in the picture. 

MILITECH AR15

https://makerworld.com/en/models/2495759-ar-15-m4-pocket-rifle-bolt-action-toy#profileId-2742962