April 17, 2026
Description
Looking for a cool simple wind spinner? Look no further.
This is a simple wind spinner with two fins. It uses a print in place bearing and everything just slides in place.
If the bearing is a bit stuck after the print. Wiggle the wheels inside around a bit. This will break the connect to the outside walls.
The max pole width that this design is made for is 19mm. Anything lower you can use the side screw to make sure it fits.
When printing the fins i have added support. It is possible to print them without this. In my testing (With P2S) this is about 50% fail chance.
Hope you all like this design. Any feedback is always welcome ❤️
License:
Standard Digital File License
RedMagic
