I present to you, the ones we all know and love! These take literally a minute to print each, which just makes printing batches extremely convenient. I want to cut time down as much as possible, because time is money!
Standard PLA will do, I just chose yellow to fit the OG aesthetic.. But always remember to either use the print profile or follow my instructions! Otherwise they may not fit, I have printed these over one hundred times, to get the perfect fit.
0.16mm is required, otherwise the seam is too large and it doesn't fit properly. And slowwww the print down a bit, not much. Just not standard, 50% your usual is perfect. Otherwise the seams don't form properly and also ruin the fit completely.
If you've followed all the instructions and they still dont fit, please check your printer. I have done everything I can to ensure they are a snug tight fit. Scaling the X + Y by 0.1mm + or - depending on the fit, is usually enough. However they should be fine.
M9PXZ
