Airsoft Mock Suppressor with Tracer Support-Short

If you are intrested in this, please check out my V2 design of this were I made both aesthetic and functional improvements.

https://makerworld.com/en/models/2813641-airsoft-tracer-suppressor-body-v2#profileId-3132198

Airsoft Mock Suppressor with support for tracers 28mm in diameter. Tracer used is Acetech Brighter R. 

Tracer Base and Body included. Supports only needed on lower hole in base. Settings should make supports easy to remove.

Unit is 35mm in diameter and roughly 80mm  length. The design of the base allows the inner barrel of the airsoft gun to stick into the base slightly before it gets to  the tracer

Use at least PLA+.