X2D & P2S Poop Bin - Hook Design

🔥Update:

• New Version prints faster and uses less Filament - 2 hours and 55g of filament
• New Small Version smaller in height at 150mm and prints even faster - 1 hour 38 minutes and 42g of Filament

Both Versions feature 1.2mm wall thickness on the 3 “non functional” sides instead of the original 1.6mm to reduce print time and filament usage.

 

Both the Original and New Version do have 150mm of actual height usable to store Poop.

The Small Version has 100mm of actual height usable to store Poop. - Just to keep in mind…

 

-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------

 

I designed this poop bin for the X2D & P2S with the mounted chamber fan on the back.

 

It is a simple hook in design and it does not touch the ground on which the printer stands on and it doesnt protrude further than the chamber exhaust fan.

It also doesnt block any of the vent holes on the back of the printer.

 

Simply remove the bottom screw of the poop chute and screw in the pin with the original self tapping screw.

Attention do not overtighten this screw since it is a self tapping screw!

 

Hook in your poop bin and youre done!

 

I highly recommend to print the pin and the chute in a high temperature resistant material like ABS or ASA since the printer gets quite toasty on the back panel if you use the chamber heating.  Filament in pictures is Bambu ABS-GF

 

 

Boost MeIf you like my work check out my other models and consider a boost. Thank You!