Specialized Fuse Comp Model

MembershipBoost Me

This is a 1.9 scale Mountain Bike based off a Specialized Fuse Comp with rotating wheels bars crank and pedals. 

  

Feedback is greatly appreciated! 

 
ASSEMBLY GUIDE 
  

• STEP 1  

Wheel Assembly  

 

 

  

Place the alignment blocks (2 White Pieces) into the correct cut outs on one half of the wheel. apply glue all round then place the second half of the wheel on to the first. (don’t forget to align the Tred pattern) (As shown below)  

ASSEMBLY GUIDE 

  

 

(Repeat step one for the other wheel) 

• STEP 2 

Rear Wheel Assembly 

Slide gears on to the right side of the rear hub. (As shown below) 

 

 

2.1 Next, slide the rotor on the left side of the hub. (Repeat step 2.1 for the other wheel) 

(As shown below) 

 

 

 

• Step 3 

Fork Assembly 

Slide the fork stanchion into the fork lower body from the bottom. 

 (As shown below) 

 

• 3.2 

Next slide in the Spring (Outer Diameter 4mm Length 30mm to 40mm) 

(As shown below) 

 

• 3.3 

Then push in the caps at the bottom 

 (As shown below) 

 

• 3.4 

Next push the stanchions into the Fork Crown.  

(As shown below) 

 

• 3.5 

Slide the Front Wheel into the fork lower then secure with Front Axle.  

(As shown below) 

 

• STEP 4 

Cockpit Assembly 

  

Slide the Stem through the Handlebar till it’s in the center. 

(As shown below) 

 

• 4.2 

Next slide on Brakes and Grips. 

(As shown below) 

 

• Step 5 

Seat Assembly 

Glue the two halves of the Seat together. 

 

• Step 6 

Main Assembly 

Get the Drive Chain and thread it through the right side of the Chain Stay on the Bike Frame. (As shown Below) 

 

Then Glue the end of the chain to the cut out on the ring. 

 

• 6.2 

Next slide the crank through the Drive Chain then the Frame and secure on the other side with the Crank Cap. 

 

6.3 

Grab the Crankarms and attach them on both sides of the crank via the square holes. Next slide the Pedals on to the other end of Crankarms. (Use a 2mm Drill bit by hand to open hole on the pedals) (Apply a little heat to the end of the Crankarm and flatten a touch if the Pedal slides back off) 

• 6.4 

Get the rear Wheel and secure it in place with the rear Axle. (As shown below) 

 

 

    6.5 

Get the Fork Assembly you made earlier and push it through the Headtube of the Frame. 

(As shown below) 

 

• 6.6 

Finally, push in the seat and glue in place the Stem. 

 (As shown below)