"Empyrean" Series Bookmarks

Taking my standard “page-edge” bookmarks up a notch with these three, all inspired by the Empyrean series!!

 

There are two plates, because the only green I had on-hand was a limey-translucent green, which I didn't love (shown in one of the three pics I posted). So to darken that up, I added a black behind it, and because four colors were already in use, I needed a pause to switch up filament colors. The plates are labeled as “pause” or “no pause”. All other settings remain the same.

 

IMPORTANT: Due to the size and height of these bookmarks, they can be finnicky, so please follow my settings and work with a clean build plate. I have tested these again and again and finally found settings that work without warping or misaligning. I work on a P2S, and it's the only printer I am truly familiar with. However, if you run into any issues, please message me, and I will do my best to help you troubleshoot! As a general rule of thumb for this design, I HIGHLY recommend a LARGE brim (mine is an outer only at 15mm), a slightly higher heat setting on your plate (mine is 60 on the textured plate), and a lower cooling setting (mine is 80%). Without these, the design can warp at stress points.

 

If you are interested in selling prints of this model, you can become a commercial member via my Patreon.

Boost MeA boost is GREATLY appreciated!!