Apple Watch Charging Pad

The story behind the design

Every time I wanted to charge my Apple Watch, the charger kept flipping over. Super inconvenient - and honestly, a problem a lot of Apple Watch users run into. That's why I designed this Apple Watch Charging Pad: a simple, effective solution that holds the charger firmly in place so it stops rotating while you're trying to charge your watch.

Features

• Compatible with all Apple Watch models and the original charging cable
• Keeps the charger stable and in place - no more flipping
• Tight fit for the cable, so everything stays neat and tucked away
• Two designated spots for Adhesive Foam Sponge strips (8 cm / ~3.15 inch) to prevent the pad from sliding around on your nightstand or desk
• Clean, minimalist design that blends into any interior

Assembly Tutorial

What you'll need:

• The printed Apple Watch Charging Pad
• Your original Apple Watch charging cable
• Optional: 2 strips of Adhesive Foam Sponge (8 cm / ~3.15 inch each) - available from the Bambu EU store

Steps:

1. Feed the cable through –  Push the charging cable all the way through the pad until it comes out on the correct side.
2. Position the charger head – Line up the round charging head with its designated opening. Start by inserting the wire side of the round head into the slot first.
3. Press down – Firmly press the round charging head into the recess. It's a tight fit, so apply steady pressure until it clicks into place.
4. Tuck in the cable –  Push the remaining cable fully into the cable channel/groove along the pad so it sits flush and stays in place.
5. (Optional) Add the foam strips – Take the Adhesive Foam Sponge Strip Roll from the Bambu EU store, cut two strips at exactly 8 cm (~3.15 inch) each, and stick them onto the two designated spots on the bottom of the pad. This keeps the charging pad firmly planted on any surface.