Heltec V4 case 2x18650 , large antenna & lanyard

An ultra-compact, space-saving enclosure designed specifically for the Heltec V4 board. This case is engineered for maximum portability and extended field use.

Perfect for Meshtastic Meshcore nodes or portable tracking projects.

Ultra-Compact Dual 18650. Designed for direct-solder battery tabs to keep the enclosure as slim as possible.
Wide antenna port expanded opening to easily accept larger, high-gain antennas.
Integrated lanyard loop. Built-in anchor point for wrist straps or paracord.
Physical switch cutout. Dedicated space-saving hole for a hardware power switch.

To successfully assemble this project, you will need:
Board mount. 1x M3 screw (8mm length) to secure the Heltec V4 inside.
Batteries  2x 18650 cells.
Adhesive. Double-sided tape (biadesivo) to securely fasten the 18650 batteries to the bottom of the case.
Power control. 1x Physical switch for the dedicated cutout.

1. Secure the Heltec V4 board using the single M3 x 8mm screw ( you can use a smaller one but NO longer than 8mm)
2. Solder your power leads to the 18650 battery setup.
3. Apply double-sided tape to the bottom of the enclosure and press the batteries firmly into place.