Ecoflow River 3 Vertical stand

I remixed this design to secure a river 3 power station to my camper. 

The original was one solid piece, and did not fit in a 256x256 plate.

so to save filament, and make installation more flexible, I carefully measured and split it at the point where it levels off.
Since now the length isn't an issue it might work for other similar units.

Original river 3 measurements: 255 x 212mm
This model is: 123 x 82mm

Also includes 4mm screw holes. You can also use double face adhesive tape.
I would recommend printing in at least PETG for strength and heat resistance if using in a vehicle.
For home use, PLA should be fine.

This is my first upload as I am VERY new to 3d printing (2 months) I will try to acommodate any mods within my limited skills.

Enjoy and happy printing.