Bambu Lab Spool Filament Clip - AMS and AMS 2 Pro

🧵 Bambu Lab Spool Filament Clip

I was always looking for the perfect spool filament clip, but most designs I tried had issues: they interfered with the AMS, came off, broke, were hard to align, or eventually became loose.

So I designed my own.

This clip is made specifically for Bambu Lab spools only and is tuned for a secure, reliable fit.

• Compatible with AMS and AMS 2 Pro 
  • Does not interfere with spool movement
  • Allows the spool to roll freely
• Uses 5 alignment points to lock securely in place
  • It won't come off after use or after drying cycles
• Tight tolerances tuned for PETG
• Designed to be durable and long-lasting
• Prints in under 5 minutes
• Uses less than 0.5 g of filament

Small, quick, and practical — print a few and keep them around.

⚙️ Installation

⚠️‼️ 

Please follow these instructions carefully. The top pins (x2) may look fully inserted when they are not. Use firm pressure to make sure they match the picture.

Pro tip: Lightly press them with pliers to ensure they go fully in and do not come loose. You should hear a satisfying snap when they fit into place. ⚠️‼️ 

🖨️ Printing Notes

Recommended material: PETG (or ABS/ASA if your spools support it)
No supports required.