Qidi X-Max 3 Camera Mount

For those who can't get the official Qidi camera or don't want to spend that much on one, I'm sharing this model. It's similar to the original design, but I designed it from scratch. It's for a very common, low-cost camera like the one shown in the pictures. I printed it in PA, but it can be printed in ABS. Printing it in PLA or PETG isn't recommended because the Qidi camera's heat could soften these plastics.

You'll also need a couple of 2mm x 5mm self-tapping screws.

As a tip, I noticed that the camera chip tends to get hot, so I added a small aluminum heatsink.