Desiccant Tray for Bambu Lab AMS

This was a well designed model but I didn't like that it was too tall to use with the stock cover. While I was shortening it I saw room for some improvements so I made the following changes:

• Reduced overall height just enough to fit the stock cover
• Added nubs to retain the desiccant tray cover in the tray
• Split the cover in half so you can leave the bottom cover in place and load even more desiccant

I super glued the bottom covers to the tray in my setup but it's not necessary.

Printing tips:

• Print everything with the flat side down
• Supports are not needed
• Use a fine layer height and outside/inside wall ordering for best fit and finish