IKEA SKÅDIS DeWalt DCB1104 (XE) Charger Holder

Keep your workspace organised by mounting your DeWalt DCB1104-XE 12V/18V XR battery charger directly to an IKEA SKÅDIS pegboard.

This mount uses two separate left and right brackets that securely attach to the rear of the charger, allowing it to hang safely on the pegboard while keeping the battery slot and charging indicators fully accessible. The design provides a clean, secure mounting solution while making it easy to remove the charger if required.

Both PLA and PETG versions have been tested successfully. PLA is recommended for most users as it provides plenty of strength for the DCB1104 charger and standard batteries. If you regularly charge larger or heavier batteries, PETG is recommended for its additional strength and improved heat resistance.

Features

• Designed specifically for the DeWalt DCB1104-XE charger
• Compatible with the IKEA SKÅDIS 76 × 56 cm pegboard (tested)
• Two-piece bracket design for easy installation
• Battery slot and charging indicators remain fully accessible
• Left and Right brackets are clearly labelled
• Low-profile, sturdy design

Printing Recommendations

• PLA when using smaller batteries
• PETG recommended when using larger or heavier batteries
• Supports required
• Print in the supplied orientation

For the best fit, ensure your printer is dimensionally calibrated and your filament shrinkage is correctly compensated. Different materials shrink by different amounts, which can affect how tightly the brackets fit the charger.

Bambu Lab has an excellent guide on filament shrinkage compensation:
https://wiki.bambulab.com/en/knowledge-sharing/3d-prints-shrinkage

Installation

1. Print both bracket pieces.
2. Remove the supports.
3. Identify the LEFT and RIGHT brackets.
4. Slide each bracket onto the corresponding side of the charger.
5. Hang the charger on your IKEA SKÅDIS pegboard.

Your charger is now securely mounted and ready for use.