A collection of kitchen and bathroom drain strainers, stoppers, and drain pads. Useful for kitchen sinks, bathroom sinks, utility sinks, bathtubs, and probably more!
Before printing, please review the list of models and their respective measurements followed by some additional notes.
General Notes:
The only model that requires support is Part 4 (sink_stopper_4_fin) of the Bathroom Sink Drain Stopper (Experimental).
No brim is necessary for any of these models.
Concentric or Archimedean Chords for top and bottom surface patterns works well for many of these models as they're circular.
The ring (part 5) must be printed in TPU filament (or similar)
Large Drain Stopper Pad
150mm diameter
TPU filament (or similar)
Engineering plate (or similar smooth built plate)
Medium Drain Stopper Pad
100mm diameter
TPU filament (or similar)
Engineering plate (or similar smooth built plate)
Small Drain Stopper Pad
50mm diameter
TPU filament (or similar)
Engineering plate (or similar smooth built plate)
Instructions for the Bathroom Sink Drain Stopper (Experimental)
Insert 2 into 1. Try pushing the teeth of 2 together and then coming in at a top down angle into 1. Then slide the teeth down and when you reach the circle, lift the center of 2 to lock in place.
Slide 3 into 1 (on top of 2) while pushing down on 2's circle tab which will lock into 3's circle.
Slide in 4 on the opposite side.
Pinch 5 to get it around 6. Pull down one side of the ring (5) until it pops into place. This is best done on the wide sides of 6. Then do the same on the opposite side to fully pop in the ring (5).
Slide 6 sideways into the notch at the top of 2.
My TPU Settings
I know this may help some people so I'm including the slicer settings I use for TPU.
DesignCraft
