Demon Slayer Mask - Hotaru

Demon Slayer Hotaru Haganezuka Mask modeled in Blender.
Scale down eyes to 99% and you will be fine.
For the eyes I paused my print (see photos) and added tulle fabric and secured it with magnets and resumed the print, this way the tulle was imbedded in the eye print. To remove outside tulle just cut it off as close to eye with exacto knife and torch excess away. When glued into mask it wont be visible.

Bambu Slicer 0.20 mm Standard setting.
Size: 157 x 108 x 232 mm
Suggestion: I print the mask standing up so the layer lines end up at the bottom of the cheeks and nose vs if you lay it flat with supports on the inside of the mask (you'll have layer lines on the middle of the forehead and middle of cheeks which will be visible when worn).
Scale down eyes to 99% and you will be fine.
For the eyes I paused my print midway and added tulle fabric and resumed the print, this way the tulle was imbedded in the eye print.