April 23, 2024
Description
This is a bracket to attach to the back of your printer and fits to existing screw holes (see diagram image) for adding a hot swappable 100mm exhaust pipe for ventilation.
Items used:
Instructions:
Use a standard M3 thread tap to thread the three unused holes on the panel (no drilling required).
You can use about a 10mm long screw no issues. The holes on the model line up perfectly and have a small tolerance to account for material shrinkage. The second printed part you need to tape to the insulated flexible pipe as shown in the photos and there is a slot which is locks onto with a small turn and allows you to hot swap your hose with other devices.
Printed and tested on a bambulabs P1S.
****Please Note****
The connector has a tolerance of 0.6mm meaning there is a little movement and if you want to make it tighter you can use some sticky tape or an elastic band around the cylinder below the notch to form a gaskett for an air-tight seal. See below image:
License:
Standard Digital File License
1,510
835
linton
