ratgdo v2.53i case

This is an enclosure for the ratgdo 2.53i board with edge mounted connectors. I designed this case to have thin walls at the connectors and exposed the terminal block top to allow it to be wired after it is fully assembled. The tolerances are extremely tight and will require you to file the edge of the PCB where the breakaways tabs were. You will also need to account for shrinkage for whichever plastic you're printing with, for Bambu black PETG I found increasing by 0.35% was enough.

I've included three bottom case variations, a clean case, one for zip ties and one with a mounting bracket.

Bill of Materials:
3x - M3 x 16mm FHCS Screws

Optional
2x - M4 x 10mm+ SHCS or BHCS Screws

Zip Ties