Brembo Caliper and Rotor Office/Workshop Clock

MembershipThanks for subscribing, I 100% appreciate you. This subscription will encourage me to design more models for your pleasure. If you have any issues with a model, please do not hesitate to contact me.

All printed at .2mm layer height

 

The rotor/disc was printed face down for best quality

 

The caliper was printed in 3 parts to reduce filament swaps and also increase quality, the top face was ironed

 

The Caliper was pinned with the supplied pins and glued with super glue, I also glued the base to the caliper

 

The rotor/disc and the caliper have orientation bumps designed in to center the clock face in the correct orientation

 

For the clock mechanism, just copy/paste the following into Amazon if you want the same one I used. This is a pack of 2 for around $7 and I only used the long thread version, typo's are not mine :) - 2Pcs Quartz Clock Mechanism Kit, Wall Clock Mechanisms Mattery Powered Replacement, Clock Movement Parts Motor Replacement DIY Repair Parts with 5 Set Hands (No Battery)

I only used the second hand (which i cut to size with snips) from the kit and printed the hour/minute hands

 

I used 4 M5 x 18 bolts along with M5 nuts to attach the rotor/disc to the hub. You will get away with around 12mm thread length.

 

After I designed and printed this, I went back and added the split lines between the rotor/disc and the carrier to add more realism

 

As an added bonus, if you'd like to wall mount this, there is a wall hanging hook with the clock mechanism, and for this you will not need to print the clock stand.

 

If you like this design/print, please consider boosting it, much appreciated. Also, post your prints, especially if you change out the colors.