Spiral Open Container - SWKOTOR - Umbrella Company

One of my favorite things! Unique storage containers! 
LARGE version here! https://makerworld.com/en/models/585009#profileId-506166

Here's a little container you find in the old KOTOR games, couldn't quite make them push up, but it's still awesome anyway! 
Can be scaled up, but don't go smaller than it is now. Great Fidget mechanism!
perfect for your Star Wars storage!

After refining it, I realized it was also the Umbrella Company logo from Resident evil, so, I printed that too!

If you want the Resident Evil 4 Umbrella Company spiral, simply print the 1 and 3 flaps, or the 2 and 4 flaps in red or white, then they'll fan out in that style. 

Instructions:
1) Snap the top flap to the 4 holes on the bolt.

2) GENTLY slide the 2nd, 3rd, 4th, flaps up the bolt, below it. The small curved holes should match up with the bottom pegs on each piece. 
3) GENTLY take the cap piece, and push the bolt with the four flaps up through the cut out area into the internal groove of the cap.
4) GENTLY snap the entire cap onto the barrel base. I included two little pegs to fit in holes to show the most accurate direction it snaps to. These MAY break off, that's ok. you can also glue the cap down at this point if you want. 
5) Once the cap is fully secured and in place, the bottom flap should again settle into a slight indention where the cutout was in step 3. This holds the flaps in place when they spin.
6) Spin away! Store your Republic Credits, Repair Spikes, Medpacks, and even the T-Virus in it!

Notes: It is designed with slow printing, to make sure all the edges match up smoothly, with ironing and such. You can adjust the settings if you like, and are confident in a fast print. I do have VERY thick sides, but it matches the in game specs and allows for space to spin the top. However, smaller things snap off and you'll find yourself printing a lot of flaps.