U.S. Army M1A2 Abrams MBT - Kit Card

Membership

Printed at .08 layer height with an initial layer height of .16mm. Due to the angles on the hull, this was the best way of reducing the the layer ridges

 

Be careful when removing from the bed as you'll rip the side supports if you're too eager.

 

Use snips to cut the supports, and an exacto knife to trim.

 

Place the gun in it's position by forcing it upwards into the turret as you hold the block at the back of the gun, it will go in, but its a tight fit.

 

If you like this print, please support me with a boost, it's much appreciated.