Optimised modular filament waste bin system

 

Boost MeIf You like my designs, You can boost them.
This is hard and time consuming work, so Thank You in advance!

IMPORTANT:

 

PLEASE read the BOM !!!

 

This is an optimised variant of the Modular filament waste system. A natural evolution.

It consists of two parts - a fixed chute and a detachable bin, which is very useful if your setup is situated on a narrow place like box or cabinet.

Both chutes and bins were redesigned for being simplified, easier and faster to print.

The chute is attached to the 3D printer with a screw and one (optional) neodymium magnet. Additionally you can use three more magnets for securing the bin to the printer (works only with X1C). The bin is separated from the chute, so you can just pull it up and trow the garbage. 

Variants:

1. With duct like here;
2. Without the duct;
3. With the taller bin - if the printer is situated on a slab (see photos);
4. With the shorter bin - this is the most common situation.

BOM:

1. Neodymium magnets, totally of 5 pcs. Ø 10x1.5 mm (the two are for the duct). All magnets are optional;
2. Screw(s) M3x8 mm, 1 pcs (2 pcs if you decide to print the duct). The screws replace the original ones of the Purge Chute;
3. Some instant glue for the magnets.