Miter saw T-track stop block

A miter saw stop block that works with T-track systems. You need to bring your own M8 bolt > 70 mm that fits in the track.

This video demonstrates how the block is used (drop-in variant)

This block can be installed in two ways:

1. Print the block alone – as shown in one of the photos with the black knob. This installation method is on-par with a lot of the storebought options where you have to insert the block from an end of the track.
2. Print w/ the end cap for M8 bolts with smaller heads. This option allows you to drop the block vertically into the track. See the video below.

User reported – the piece may come out a bit tight depending on the printer, the filament used, etc. Consider scaling it down to 99% if you are concerned about this.