Field Charger Case SkyRC B6neo - print in place

Transportation Storage for SKYRC B6neo charger

Hi there. Since I got my nice and small battery charger from SkyRC I thought about a good solution for field charging my batterys and a small transportation for the most basic stuff, the charger and the cables for it.

I designed it to fit a smaller USB-C cable or a longer power cord to a battery/bigger battery pack.

Everything is print in place, it is one print and no tools are needed.

You can choose from three build plates. One with an drone logo, one with a plane and the last one blank.

Tips for printing:

I would keep the orientation at the build plate since I had better results with this than in an 45° angle since the joints are designet kinda tight with .15mm play to each side.

After printing you need to break them free. Depending on your filament you will need some wiggle till it gets more and more loose to the final state. Stay patient with this to not break them.