RODE Wireless GO Snap Latch Case With Insert

RODE Wireless GO snap case based on my previous drill bit case - Assembly the same as in the video above. The RODE case only has one insert.

This rugged Pelican style case only requires two different pieces of hardware and has been successfully snapping open and shut hundreds of times without failure. Insert ~10mm thick piece of soft foam into top half of case to keep evertyhing snug.

Split pin sizes are 1/8" x 1-3/4" and 1/8" x 3/4"

► https://amzn.to/3LJS1DV

► https://amzn.to/3dOSO9P

► https://amzn.to/3Scn25C

As an Amazon associate I may earn a small commission (at no extra cost to you).

Print the top and bottom cases at 0.2mm layer resolution and 20% infill. Latches can be printed at 0.2mm layer and 20%… they will likely get calculated as solid anyways. PLA+ for all parts will work fine - can use PETG if you're worried about PLA cracking (has never happened to me)

#3dprinting #tools #maker

****************************************************************

If you enjoy and have benefited from my content and are feeling generous I would love your support! You can "buy me a coffee" here:

► https://www.paypal.com/donate/?hosted_button_id=V2T6MEFUGP73Y

By supporting my channel you are encouraging me to continue with this time consuming endeavor. A lot of time goes into design work, building my projects, filming the videos, editing the videos, etc. Plus it all costs money! Your generosity goes a long way in helping me bring you better content as often as I can!

Follow me on Instagram!

► https://www.instagram.com/embracemaking/