Judgement

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 

The Model is 200x200mm in size. You can change the X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

 

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Grey Transmission Distance: 1
PLA BambuLab Basic White Transmission Distance: 5
This print uses 4 unique filaments. Substitute as needed.

 

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Blue Gray
At layer #13 (1.12mm) swap to Grey
At layer #20 (1.68mm) swap to White for the rest.

Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!

MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!