Hanging Planter box

This is a hanging planter designed using Fusion 360. It has embossed leaves on the front of the planter. I felt the design was a little to snug for the build plate so set it for 94% print (you can change to 100 if you wish) and it's about 9 inches long from top to bottom. I used standard supports for the print and utilized Bambu support PLA which did a great job. Used adaptive layers to try smooth the peak of the curve out ( I laid the back on the bed as I felt it would be strongest that way) but still has some layering towards the peak.

Update: 6/28/24 - I have added an insert for the planter as a separate print profile. Used the same support settings and scaled it down to 88% before printing for it to fit the planter (my calculations were off and it is easier to scale to 88% in Bambu labs). Insert has a couple of holes at bottom for water to escape when watering.