Filament Clip for bambu spools

This filament clip is designed in such a way that you can easily press it into the holes of the Bambu Lab spools. Then the filament can be clipped into the holder or you can push the filament sideways through it. This prevents uncontrolled unwinding.

It can be left permanently on the spool without causing any issues, even in the AMS. Important!!! It may only be placed on the right side of the spool (As can be seen in the GIF). If it is placed on the other side, it will get stuck in the AMS. 

There is a big problem with the new AMS 2 Pro. In the old AMS, the guide is placed in such a way that you have to use the clip on the right side everywhere. In the new AMS 2 Pro, it is unfortunately the case that the guides are not always on the same side, which means that the clip has to be placed differently depending on the compartment. (see image of AMS 2 Pro)

In case you want to remove the clip from the spool, I have created this here. It is needed because the clips clamp very stable in the spool.

Printing setting

-Layer height: 0,12 mm

-Infill: 50%

For the rest you can use standart settings