Caliper Battery Compartment Replacement Cover

While drying my disassembled (cheap) set of calipers due to some unfortunate water-ingress I seem to have misplaced its battery compartment cover.
So instead of looking for it I made this model, which 'only' took about 5 iterations.

The model prints in less than 10 minutes, although I turned the speed way down, which does seem to (further) increase print quality.

The calipers are made by Ovibell GmbH and are called 'Workzone DC-1' (Art.Nr. 650080).
Visually they appear to be very similar to the ones from HBM, see the post from Rick219: https://makerworld.com/en/models/458600

The default version is a one-color print, but if you want to be reminded of the genius who lost the original cover, there's also a version with a logo for your amusement.

The fit is somewhat tight, but for now it works just fine.

Printed in basic PLA, with most speeds at about 75%.

-------------------------------
Update 04-07-204:

I've refined the general geometry, slightly loosened the fitting tolerances as well as added some grooves for better handling.