MatchBoard - Ludo (Portable)

Introduction

You want to enjoy Ludo while on the go or secretly in school? This is it!

It is foldable and therefore fits into a normal matchbox and in your pocket without any problems, so you can take it basically everywhere! It takes around 2h to print in place and is more than fun to play. Each field of the board is around 5x5mm in size, so it is not too small.The Figures are about 15mm tall. And if it is to small for your fingers, you may use the tweezers i designed for moving the pieces.

The optional magnets in the board are used for holding the folding edges closer together, therefore make the board more stable on your desk.

Materials

• Filament: Any (Hard) - PLA, PETG, ABS, ASA, … (4 Colors recommended)
• (8x) 2x2mm Magnet (optional) : https://amzn.eu/d/053MxUvG

 

Boost MeThanks :D

Setup

1. Choose between the board with or without magnets
2. Print board from the profile, select 4 Colors
3. (When chosen with magnets: Insert the Magnets into the print when it pauses. Pay attention to the correct orientation!)
4. Print the figures, they print in one go with print-by-object
5. Print the tweezers
6. Done!

Let me know if there is anything to change! Have fun with it :)