8x50mm Wall Plug

Hello, today I present to you this neat little plug.

Features:

• Made to fit in 8 diameter holes
• No extra support needed
• Under 2.2g of filament
• Printed using 0.4mm Nozzle

(The printed models in the picture was made using PETG but I am more than sure that it can be printed in regular PLA, I just don't have any at this moment to test that. Left is the V3 and right is V2)

Settings:

• Initial Layer Height: 0.25 mm
• Layer Height: 0.25 mm
• Infill: 100% 

Size Changes:

• For Ø10mm Holes, Increase the model size in the slicer to 121.25%
• For Ø9mm Holes, Increase the model size in the slicer to 109.12%

• For Ø7mm Holes, decrease the model size in the slicer to 84.87%

  (Please note, The current model can not become any smaller than 84.87% due to the hook “support” becoming too small to print with a 0.4mm nozzle)

If Any Flaws are found please post them in the comments so that I can improve the design <3

Edit Log:

• 2024-07-30 Made the print 25% Cheaper and made the center hole wider on the inside.