Desk trash can / waste bin with a choice of flip lids: choose between Bear, Mouse, or Plain lid designs. The bin (excluding lid) is roughly about 10cm / 4" in diameter and in height.
Printing
Please refer to the uploaded print profile/3MF file for variable layer height, support and brim settings of the different parts.
Good bed adhesion is required, especially for the dome-shaped parts.
Choose between bear, mouse, or plain lid designs to print.
Bear and mouse lids are pre-colored for two-color printing in the uploaded print profile.
Tip: The uploaded print profile uses 0.2mm layer height. You can adjust the layer height smaller if you prefer a finer layer resolution for the dome-shaped parts.
Assembly
There are 3 parts: outer lid, inner lid, and bin.
After removing the supports and brims for the two lid parts, slide the outer lid over the inner lid.
Fit the lid assembly onto the bin.
The flip lid motion will be smoother after some use.
There are also Lion and Panda designs for this bin: https://makerworld.com/en/models/545808#profileId-463644
01makes
