Headset Hanger

Simple Headphone/headset hanger with built in wire hook and 2.5/3.5/¼ inch Jack.

Compatible with desk thickness up to 55 millimeters/2.2 inches

Comes as solid body or with slot cut outs.

Screw comes as full length and can be cut down to size.

it is recommended to use cork or other compressible material on the underside of the clamp.

Please ensure your filament is dry before printing, the screw is a friction fit to ensure it does not unscrew itself from the clamp. The screw should not be loose. Wet filament will cause the screw to print oversize. The tolerances on this model are designed for the x1c using PLA. PETG uses different tolerances than PLA and tends to print larger. Using the screw will take a little bit of force but should now be impossible to rotate. 

Last word of advise: do not print these in silk filaments, silk filaments have a lower layer adhesion than regular filaments which may cause some structural issues on the thinner parts of the print. If you still want to print with silk I would advise to increase the infill and wall count or use the strength settings.