Peppered Cory Hueforge

Picture of a little cory!

Note The grey filament I used in the photos above is a lighter shade of grey, I recommend a darker grey for the best results

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

All PLA Filament

Swap Instructions:
Start with Black
At layer #14 (1.2mm) swap to Steel Grey
At layer #20 (1.68mm) swap to Ivory White for the rest.

If not using AMS, add pause at layer # for manual filament change.

This is for NON COMMERCIAL USE ONLY.