Serpent Skull

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 

The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.2mm

 

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Silver Transmission Distance: 0.5
PLA BambuLab Basic White Transmission Distance: 5
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Beige Transmission Distance: 8
This print uses 6 unique filaments. Substitute as needed.

 

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Blue Gray
At layer #8 (0.72mm) swap to Silver
At layer #10 (0.88mm) swap to White
At layer #15 (1.28mm) swap to Red
At layer #21 (1.76mm) swap to Beige for the rest.

Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!