Rose Shaft(0,1mm Layerheight for the first 3 Layers)
Pin
Blossom (0,1mm Layerheight)
Assembly Instructions:
Rose shaft:
After Printing the the shaft hold it in the direction it was printed and use heat from a lighter under each green leaf.
Just a small and quick flame. You will see that the leaf will instantly curl into the right direction. afterwards you will have a leaf “bowl” on top of the rose shaft.
If you want bigger leafs, just use a brim!
Blossom:
After Printing the Blossom curl it up from the side without the hole. If you have a bit trouble to wind it up, use warm water or a hairdryer to soften the petals!
The Last piece (Hole) need to be bended under the Blossom as a “base” you can use a bit glue to hold down the Blossom to the Base part.
If you want bigger Petals, just use a brim!
If you like, you can also lasercut the blossom out of some thin material. just use the svg file!
Important! Don't print the blossom file thicker than 0,3mm. Otherwise it will be to thick to wind it up!
After these Steps you can push the pin trough the middle of the blossom through the hole in the base of it and mount it (with a tiny drop of glue) onto the shaft!
And you are Ready with your realisic 3d rinted rose with filigree petals
Filament used: Redline Raspberryred: Red Redline Apple Green: Green
Here is a longer Video how to assemble it: https://www.reddit.com/r/3Dprinting/comments/srkuiz/someone_posted_my_design_of_a_3d_printed_rollup/?utm_source=share&utm_medium=ios_app&utm_name=iossmf
3DPrintNovesia
