Desk Cable Clip V2 (Reinforced)

Update 26.12.24

A profile with a 6-slot clip for all sizes has been added to the print profiles.

==========

Update 22.10.24

The gap in the hinge has been increased slightly, now it requires a weak force to close it for the first time. If your hinge breaks or requires a lot of force, please check your printer, settings, plastic, etc.

==========

With the previous version of the model, some people expressed concerns that the model might break in some places, so I significantly strengthened all the questionable parts.

After printing, the movable joint may be slightly glued. Wiggle the joint back and forth until you tear it out of place. Perhaps this is the fault of the 0.2 layer, perhaps 0.16 and 0.12 will not glue the parts at all or at least slightly, but I have not experimented with this.