Adapter Plate eSUN PETG cardboard

If you tear of the card borad sides from the eSun PETG, the filament does not fight tightly into a bambo spool. Because the whole role is a bit loose on the bambu spool, the filament get's pulled tight in the gap and then is stuck. With the adapte plate that problem is gone. Other adapters that are in addition to the card board didn't work with my AMS (reasons where: little bows in the card board, wrong diameter of spool adapter…). Tear of the card board on the side where the beginning of the filament can be seen in the inside of the role. Place this gap on the little pin of the bambu spool. Put the adapter plate to the other spool side. Tear of the other side of the card board and put on the second half, turn till it clicks into place.