Goddess

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 

The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 4.5mm

 

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Silver Transmission Distance: 0.5
PLA BambuLab Basic Green Transmission Distance: 2
PLA BambuLab Basic Light Green Transmission Distance: 2
This print uses 6 unique filaments. Substitute as needed.

 

Swap Instructions:
Start with Black
At layer #12 (1.04mm) swap to Blue Gray
At layer #20 (1.68mm) swap to Jade White
At layer #31 (2.56mm) swap to Silver
At layer #32 (2.64mm) swap to Black
At layer #37 (3.04mm) swap to Green
At layer #41 (3.36mm) swap to Light Green
At layer #49 (4mm) swap to Jade White for the rest.

Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!

MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!