Woven

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 

The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 4.5mm

 

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Silver Transmission Distance: 0.5
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments. Substitute as needed.

Swap Instructions:

Start with Black
At layer #15 (1.28mm) swap to Blue Gray
At layer #22 (1.84mm) swap to Silver
At layer #39 (3.2mm) swap to Jade White for the rest.
 

Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!

MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!