Paperclip Box (2 color only on first layer!)

This is a small box for paper clips and other small studying utensils, that would get lost otherwise.

 

For this model you should not use brittle filaments, I used PETG and PLA, both worked for me.

To test if your filament works, take a raw piece of from the spool and bend it by 90°, it should not crack (color may change a little on the bending point).

 

Assembly is done in less than 2 minutes:

• Take the print off the bed when cooled down
• Bend all the edges by 90°
• Apply some super glue where the two edges meet
• Apply force with your thumb and index finger on the glued edge until the glue is dry (typically around 10-20 seconds)

• Add the drawer part from plate 2 and you're done, congratulations :-)

 

Boost MeIf you like this model, consider leaving a boost. Thank you!