Elegoo cardboard spool rings for AMS (V2)

Attention!

There are 2 different ring sizes, as stated in the info below.  If you print plate 1 (the new (smaller) spool size and it seems too small, you probably have an older spool and should try printing plate 2, which is about 1mm bigger for the older spools.  If you printed plate 2 and it's too big, then print plate 1 instead.  Unfortunately there's really no way of knowing what you have unless you can carefully measure the diameter of the spools or happen to be lucky and have 1 of each on hand so you can see the difference.

Why?

I got tired of trying to get other adapter rings to stay on the Elegoo cardboard spools; they kept popping off.

 

What's different?

These spool adapters have a small lip on the inside that makes them snap over the spools and stay put.

 

Anything else?

This model includes two plates, each with a different size ring.

• Plate 1: 201mm ring for the newer Elegoo spools which are slightly smaller.
• Plate 2: 202mm ring for the older (slightly larger) Elegoo spools.

Note: You need to print TWO copies of any ONE plate for a given spool. In other words, DO NOT print plate 1 then print plate 2 expecting that to work - you will have two different sized rings if you do.

 

Note 2:  As others have said, this model needs to be printed at the .16mm layer height specified in the original print profile, due to the tolerances needed for it to still fit in the AMS and the spool filament holes.

What's New?

Version 2:  

• Reduced size of Large Ring by .5 mm so that it better fits in AMS
• Added “L” to large ring and “S” to small ring (under the logo) to help identify which is which
• Increased the filament hole size on large ring.

Version 1:

• Initial upload.

Boost Worthy?

Boost MeIf you print and like these better than all the others, why not show me appreciation by boosting my ego (and my account)?