WZ-551 6X6 infantry fighting vehicle中国92式轮式步战车

WZ-551（zsl-92） is a prototype Chinese Armored Personnel Carrier that appears in Wargame.The ZSL-92 wheeled armored vehicle, codenamed "WZ551", also known as the "Type 92 armored personnel carrier", is a 6×6 wheeled armored transport vehicle developed by China. It was equipped in the mechanized forces of the People's Liberation Army of China in the mid-1990s. The chassis adopts an isometric 6×6 drive mode. Passengers enter and exit through the rear door and side door. There are two ducted propeller propulsion devices at the rear of the vehicle body to improve the ability to move on water. Initially, the WZ551 was equipped with a single-person turret (weapon top) with a ZPT-90 25mm caliber machine gun. The standard weapon of the ZSL-92A is a Type 88 12.7mm caliber anti-aircraft machine gun, and it can also be equipped with various diversified weapons according to different uses.

I made this model in fusion 360. To facilitate 3D printing, some details are not shown or are not strictly in proportion. Please use glue to glue the parts together. Press the turret into the car body. If it is too tight, you can use a heat gun to slightly heat the lower body clip.

WZ-551是《战争游戏》中出现的中国装甲运兵车原型。ZSL-92轮式装甲车 ，工程代号“WZ551”，也称为“92式装甲运兵车”，是中国研制的一款6×6轮型装甲输送车，1990年代中期开始列装中国人民解放军陆军机械化部队。底盘采用等轴距 6×6驱动方式，乘/载员通过后门和侧门进出，车体尾部有2个导管螺旋桨推进装置，可提高水上行动能力。 最初WZ551安装有ZPT-90式25毫米口径机炮的单人炮塔（武器顶置），ZSL-92A标准武器为一门88式12.7毫米口径高射机枪，还可依用途不同换装各种多样化武器。

我在fusion 360制作了这模型，为了方便3d打印，一些细节没有展现或者没有严格按比例。请用胶水黏合各个零件。炮台按入车身即可，如果太紧，可以用热风枪稍微加热下车身卡扣。

2024.9.6：

I am very sorry. I exported an incorrect version before, which caused problems with the axle hole of the left rear wheel. Thanks to my friends for their feedback. I have repaired and uploaded it again. I apologize for the loss caused. For the previous printing errors, you can use a soldering iron or drill to drill holes. Because they are hidden behind the wheel, they have little effect on the appearance.

非常抱歉，之前导出了一个错误版本，导致左后轮车轴孔出现了问题，感谢朋友的反馈，我重新修复上传了，对造成的损失深表歉意，对于之前打印错误的您可以使用电烙铁或者钻头打孔，因为隐藏于车轮后，对外观影响不大。