Support Panda Touch P1S-P1P

Here is my Panda Touch stand, it was more difficult to do the procedure than to assemble this stand.

Requires mechanical components such as nuts and screws, has a list.

Required components:

**Accessories:

-Panda Touch

-USB type C cable length 200/300mm

**Printed parts:

- INCLINED BASE

- PANDA TOUCH SUPPORT

**Equipment:

- 2mm Allen key

- 2.5mm Allen key

**List of screws/nuts:

- Nut M3 / quantity four pieces (AB005)

- M3 Allen screw, stem length 8mm / quantity six pieces (AA037)

- M3 conical head Allen screw, stem length 10mm / quantity four pieces (AA087)

Disassembly instructions: I advise you to turn off the power to the printers first

STEP 1 / 6:

-Remove the display

-Remove the connector

STEP 2:

-Remove only this 2.00mm Allen screw

STEP 3:

-Drop the body

STEP 4:

-Must leave the premises

STEP 5:

-pay attention to the cable

STEP 6:

-place them on top of the glass, balanced

Assembly instructions:

STEP 1 / 5:

-If the cable doesn't fit, change the section, I used a cutter

STEP 2:

-bend the cable before inserting it

STEP 3:

-pass the cables inside the slot

STEP 4:

-reassemble the body

STEP 5:

-put the screw back

Mounting the upgrade:

STEP 1a /:

-necessary components

STEP 1b:

STEP 2:

-sort out the wiring, remember, you can use it whenever you want

STEP 3:

-
insert the nuts on the seats

STEP 4:

-Assemble the stand, the screws thread into the plastic in this step

STEP 5a:

-Using the conical screws, mount the base of the panda touch

-connect the cable USB C

STEP 5b:

-connect the cable

STEP 6:

-connect the USB cable to the printer

STEP 7:

-fix the cable

YOU'RE DONE, YOU NEED TO SET THE POWER OF THE PANDA TOUCH

If you leave me a Boosts I will be grateful, available for any clarification also on the Panda Touch.

Good press from Mc2.Projectd3D