Enchanted Forest Bookmark - Hueforge

This a bookmark I used to teach myself the Color Aware setting in Hueforge. The original file is pretty large, so I normally scale it down to 55mmx165. IT IS VERY IMPORTANT THAT YOU DON'T SCALE THE Z SETTING. THE HUEFORGE PAINTING WILL NOT WORK WITH A SCALED DOWN Z SETTING.

This one has quite a few color changes, and I only have one AMS myself, so using Cloudy Nostalgia's guide for more than four colors was super helpful to me - so I'm just going to use his instructions:

• Because a hueforge is essentially laying different colors on top of each other it is possible to print more than 4 colors in a hueforge. In a nutshell we take advantage of the filament run out sensor to pause the print for us and then allows us to change any other filaments at the same time.
• The example below is for a 5-color print but carry on the same idea if you need more.
  • Load AMS slots A1, A2, and A3 with the first 3 colors used. Leave the 4th slot unloaded.

  • Send to print. When asked which AMS slots have which colors assign the first 3 colors on A1 – A3 and the fourth color in the print to A4 (keep in mind it will not show a loaded color because it isn’t loaded). The fifth color will be assigned to A1 (I like to keep it sequentially but any other slot besides A4 will do)

  • The printer will give a warning that some of the assigned colors are not mapped in the AMS just click confirm.

  • The printer will start printing and print automatically until it reaches the 4th color. It will tell you the filament ran out and you need to replace it. At this point I would load my 4th color AND my 5th color into the AMS A1 slot like I assigned it.
  • Continue the print and that’s it! You can repeat this as many times as you need but just doing this once allows you to print 7 colors with just one swap.

Project: forest bookmark.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 147x441mm in size but size it down to 55x165mm for proper bookmark size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.4mm and the Actual Depth is 2.5mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA Kingroon Blue Transmission Distance: 3.6
PLA+ 3DHojor Purple Transmission Distance: 2.6
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA+ Aceaddity Red Transmission Distance: 4
PLA Kingroon Orange Transmission Distance: 7.6
PLA Kingroon Yellow Transmission Distance: 7
PLA Default White Transmission Distance: 5
PLA Anycubic Black Transmission Distance: 1.2
PLA+ Esun Forest Green Transmission Distance: 2
PLA+ Kingroon Green Transmission Distance: 4
This print uses 11 unique filaments

Swap Instructions:
Start with Black
At layer #5 (0.48mm) swap to Blue
At layer #7 (0.64mm) swap to Purple
At layer #9 (0.8mm) swap to Jade White
At layer #14 (1.2mm) swap to Black
At layer #15 (1.28mm) swap to Red
At layer #17 (1.44mm) swap to Orange
At layer #19 (1.6mm) swap to Yellow
At layer #20 (1.68mm) swap to White
At layer #23 (1.92mm) swap to Black
At layer #24 (2mm) swap to Forest Green
At layer #26 (2.16mm) swap to Green
At layer #28 (2.32mm) swap to Jade White for the rest.